Introducing the ProX XC-IEC14-06, a 6 ft. replacement power cord built to take over for the thin, undersized cable that shipped in the box with your gear. Every rack, every DJ booth, and every powered speaker on the stage runs on an IEC cord, and it is almost always the cheapest part of the whole signal chain. That is why it is the first thing to fail. The XC-IEC14-06 is built the opposite way, with a heavy 14 AWG oxygen-free copper core, and molded ends that hold their grip after hundreds of load-ins. For working professionals who need power that stays connected from the first note to the last, this is the cord that ends the problem.

NEMA 5-15P Edison Plug The wall end terminates in a standard 3-prong NEMA 5-15P grounded plug, so it drops straight into any 120V household outlet, power strip, wall box, or rack mounted power distribution unit. The third pin carries a true safety ground back to the source, which is exactly what you want when you are tying multiple pieces of powered gear into one circuit.

IEC 60320 C13 Female Connector The gear end uses the universal IEC 60320 C13 female connector, the same inlet found on the back of the vast majority of professional audio, video, and lighting equipment. That includes power amplifiers, powered speakers, mixing consoles, rack processors, media servers, computers and monitors, video switchers, and lighting controllers. If your gear has a removable power cord, this is almost certainly the connector it takes.

14 AWG Oxygen-Free Copper Conductors Inside the jacket are 14 AWG oxygen-free copper conductors, a noticeably heavier gauge than the 18 AWG and 16 AWG cords that typically ship with equipment. Heavier copper means lower resistance, less voltage drop across the run, and less heat buildup under sustained current draw. When you are pushing a power amp hard through a long set, the cord feeding it should never be the weak link.

Flexible PVC Jacket The outer jacket is a long lasting flexible PVC that stays pliable in cold rooms and coils clean at the end of the night. It resists the scuffing and crushing that comes from being stepped on, rolled over by a case, and stuffed into a road box week after week.

6 Ft. Working Length At 6 ft., this cord gives you enough reach to get from a rack mounted power distro or a stage box up to the gear without leaving a pile of excess cable coiled behind the rack. It is the practical length for rack use, booth setups, and back of house positions where a longer cord just becomes clutter.

Tested One Cable at a Time Every XC-IEC14-06 is tested before it leaves the building. Not a sample from the batch, but each cable individually, so the one you pull out of the case at 6 PM works the way it did on the bench.

Sold Single or by the Box The XC-IEC14-06 is available as a single cable or in a 50 piece master box. If you run a rental inventory, a house rig, or an install crew that burns through cords, buying the master box gets you a full set of matched spares in one shot.

Each cable consists of the following:
• 14 AWG (OFC) Oxygen-Free Copper Conductors
• Maximum Signal transfer and tone quality
• Long Lasting Highly Flexible PVC jacket

Designed by Professionals. Built for Performers. Backed by 40 Years of Excellence.

ProX products are designed by a team of seasoned industry professionals who know firsthand what it means when power fails mid-show. Since 1984, ProX has built its reputation on one principle: every product must perform as hard as the professionals who depend on it. We listen to our customers, and their real-world feedback directly shapes the products we bring to market. The ProX XC-IEC14-06 is a direct result of that collaboration. When you choose ProX, you are investing in four decades of hands-on expertise and a brand that has never stopped raising the standard for live performance gear.